jy score friday

was on my way home friday from a trip to delaware and decided to hit jy. my freind told me they had a occ , they did and i got a nice front bumper it was light blue with gray bottom. does anyone know if you can get the chrome strip for it? the chrome is bad but everything else is good. is the chrome the same as the tbi caprices?

I'm 95% sure that the front chrome is the same as the Caprice's

John there is a guy on ebay that sells the chrome strips in 3/8 and 1/2 inch widths in chrome.
When I find it I will post the info.

thanks jim

Nice find John!!! Will look SMOK'N on your wagon.......

John, there is about 15 companies selling 8 foot lengths of both 3/8 and 1/2 inch strips.Still
looking for the outfit that only uses 3M tape on the strips but havent found yet.Will keep
looking!

I have a box in the shed with the stuff I use on the Buick. I'll get it in the morning.

Did the OCC have good cladding? I need a 92 passenger's side front door cladding. I also need a 91 rear driver's side door cladding, and a rear quarter cladding

BigBlackBeaSSt wrote:

Nice find John!!! Will look SMOK'N on your wagon.......

you know me tim i am not 100% sure what i will do.

Fred Kiehl wrote:

Did the OCC have good cladding? I need a 92 passenger's side front door cladding. I also need a 91 rear driver's side door cladding, and a rear quarter cladding

fred i am pretty sure it was a 92 the owners manual was on front seat the dr fender was gone and the drivers door was leaning on the car. i will see if i have the reciept with phone # to see what they would want for the cladding. this u pull it is a little pricier than the one i usually go to

Thanks

I'll take pics of the OCC stuff I have. I can never remember which is which. I can bring it down to Daytona.

My email is jfkiehl@ij.net

fred was going past there today but they where closed. i will check tomorrow. oh do they come off like a door panel or are they bolted on?

They have 4, 11mm castle nuts, 2 at each top, and bottom corner, and there pins along the top edge (use a panel tool). The doors have a metal retainer along the bottom which is held on to the door by the 2 lower castle nuts.

For the quarters, there are #2 phillips head screws along the bottom of the wheel well, and in the doorsill, as well as a couple along the bottom edge. The top edge is held by pins, and the rearmost fastener is a double pin. Try to keep them whole. If it is a 91, get the rear fly away door trim. If the screws under the wheel opening are giving you a hard time, grab them with a channel lock pliers end to end, and rock them back and forth a few times.