some pics of riv console going in

i have been working on putting a riv console in my wagon here are some pics off how it has been going. these photos show the studs i welded in from under the car for shifter and then the mounts for the rear of the console

[IMG]http://i50

one pic of rear mounts did not go here it is

i am almost done here are some pics



last pick i tried to show the light i put in it

Very nice...really flows into the dash well!

Thats some very impressive mods you are doing and it looks like a factory install.Did you have to yank the tranny to make room for the welding?More pics from the back seat looking forward to dash please.
Take Care
Jim aka Flasheroo

i used a magnet under the car to hold stud in place then welded from top. one bolt ended up on a little bit of an angle {notices it to late} i used a counter sink bit to bevel the hole so the weld would not interfere with anything. i will post a pic of factory console later i removed a good part of it.

Looks great! I always loved the riv consoles!

Boy that looks nice...... See it in person very soon!!!

thanks for compliments. i am going to go work on wagon tonight. i have to put wheel wells back in. i will take pic of the extra console to show how much i removed

here is pic of a console before i cut it. i cut the top off with the ash tray

looks good, I can't wait to get mine finished.... Did you use an f-body shift cable?

Ooops,
I saw in another of your posts that you used a blazer cable, sorry.

WagonmasterRuss wrote:

looks good, I can't wait to get mine finished.... Did you use an f-body shift cable?

Damn that looks good! Any plans to hookup the rear ducts?

no i gutted the duct work. i am going to run 2 power ports back there so kids can plug in there games. the only problem will be the shape of the part it bends in 2 directions looks like a tough part to make

here are some photos of cd holder i talked about on another post
the way i got it



this is what i had in old cd player hole just black plastic. to get it somewhat nice for wf


cut to fit and cleaned & painted will show installed later



if you look close the little window turns red if there is a cd in that drawer

hers pic installed

The more I see the pics, the more I want this in my car right now lol! The only thing I'm nervous about is the wiring. Not comfortable with that. Other than that, it looks pretty easy to put in.

the wiring is easy. on mine it was black- ground, green -shifter inter lock (did not use), gray- lights, brown -power port on side . the cig lighter i ran and tied into factory cig wires. the gray wire for lights and the black wire i hooked them up to ash tray lights